Hey guys, I just received an Elite AP-4000 avionics unit with a 430 gps. It is a big upgrade from my AP-3000 where I was stuck using Elites old software.
I am looking for some tips about the best way to get my equipment setup using X planes 10.
I'm sure this is a dumb question but my old simulator with the AP-3000 and the Cirrus 2 yoke uses a universal control interface. Do I still need this for my new setup?
In the Elite AP-4000 manual it talks about how other hardware with a serial connection is not compatible with X-planes 10? Is there a work around for this?
Thank you for any help.
0
Newbie needs help setting up AP-4000, Cirrus 2 serial, and X-planes 10
Started by
NatGeo
, Nov 13 2016 05:17 PM
No replies to this topic