2 replies to this topic

[Flyers]

Iv notice at the airport KOAK Oakland all the AI Traffic is going to Runway 29. Oakland uses Runway's 29/9R/27L9L/27R

How can I fix this issue so the General Aviation Traffic goes to runways 9R/27L9L/27R.

Am using Mach1 Design Group OAKv.2

Any Ideas??  

Edited by Flyers, 05 June 2011 - 03:48 PM.

[IBtheSarge]

Flyers, on Jun 5 2011, 04:45 PM, said:

Iv notice at the airport KOAK Oakland all the AI Traffic is going to Runway 29. Oakland uses Runway's 29/9R/27L9L/27R

How can I fix this issue so the General Aviation Traffic goes to runways 9R/27L9L/27R.

Am using Mach1 Design Group OAKv.2

Any Ideas??  

You can try the STAR tutorial (see sticky).  The main problem I've found, however, is that some airports seem to have set wind conditions.  If KOAK is hard-coded with winds from 110, then runway 29 is always going to be the preferred runway.  You might also try to use AFCAD to "break" the link between the parking areas and rwy 29/11 to see if that forces the aircraft to use 27/9 L/R.

[Flyers]

sarge, on Jun 5 2011, 09:00 PM, said:

You can try the STAR tutorial (see sticky).  The main problem I've found, however, is that some airports seem to have set wind conditions.  If KOAK is hard-coded with winds from 110, then runway 29 is always going to be the preferred runway.  You might also try to use AFCAD to "break" the link between the parking areas and rwy 29/11 to see if that forces the aircraft to use 27/9 L/R.

Thanks , Sarge double check if that will work.