Hi All,
In the standard 737, there are two Nav radios. There is no way of selecting them individually. That said, when I press VORLOC, does the aircraft look only at Nav1?
Thanks in advance for your wise counsel!
Best,
Lucky
/////////
1
3 replies to this topic
#1
Posted 28 December 2013 - 12:39 AM
#2
Posted 28 December 2013 - 02:02 AM
How do you mean, selecting them individually? On the pedestal you can set both NAV radios to a different frequency.
I think the VOR/LOC always uses NAV1 though.
I think the VOR/LOC always uses NAV1 though.
#3
Posted 28 December 2013 - 02:24 AM
Hi Drak,
Thanks for your input. By selecting individually, I mean the ability to link either one exclusively to the VORLOC.
I too suspect that the VORLOC only looks at Nav1, trouble is it isn't documented anywhere ---
Best,
Lucky
/////////
Thanks for your input. By selecting individually, I mean the ability to link either one exclusively to the VORLOC.
I too suspect that the VORLOC only looks at Nav1, trouble is it isn't documented anywhere ---
Best,
Lucky
/////////
#4
Posted 10 June 2014 - 01:53 PM
It's documented in PMDG's FCOM2 manual: if you select autopilot A then VOR/LOC uses Nav radio #1, if you use AP B then it's Nav radio #2.
Ralph
Ralph